Software Downloads

Datacap’s out-of-scope ActiveX control for NETePay supporting a variety of EMV-enabled hardware options.

For information on supported devices please see our Compatible devices page.

Release notes for v1.75

• Support is added for Pax A800 devices. This device is similar to the Pax A920PRO except that the MSR is on the side rather than the top. New SecureDevice values are below.
• • EMV_A800_PAYMENTECH
  • EMV_A800_VANTIV_E2E
  • EMV_A800_TSYS
  • EMV_A800_TSYS_VOLT
  • EMV_A800_RAPIDCONNECT
  • EMV_A800_RAPIDCONNECT_E2E
  • EMV_A800_HEARTLAND
  • EMV_A800_DATACAP
  • EMV_A800_DATACAP_BLUEFIN
  • EMV_A800_EVO
• Support is added for the IDTech VP3350. The VP3350 supports tap, chip and swipe, credit only. This release supports the VP3350 with the Datacap TDES PAN key. The new SecureDevice value is below.
• • EMV_VP3350_DATACAP_E2E
  • For Verifone P400 devices, this version explicitly disables the U01 command – external AID selection. The next version will enable the U01 command. This will allow an ISV to move back to this version if there is an issue with the U01 command in next release.

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.90

• Support is added for Pax A800 devices. The A800 is similar to the A920PRO except that the MSR is on the side rather than the top. The PAX devices support Credit, Debit, EBT and PrePaid. New SecureDevice values are below.
• • PAXA800
  • PAXA800_DATACAP_E2E
  • PAXA800_DATACAP_BLUEFIN
  • PAXA800_VANTIV_E2E
  • PAXA800_EVO_E2E
  • PAXA800_RAPIDCONNECT_E2E
  • PAXA800_TSYS_VOLT
  • PAXA800_HEARTLAND_VOLT
• Support is added for the IDTech VP3350. This release supports the VP3350 with the Datacap TDES PAN encryption. The VP3350 supports swipe, Credit and PrePaid only. It supports GetPrePaidStripe and GetPrePaidStripeAllTracks, but it does not load a whitelist. The new SecureDevice value is below.
• • IDTVP3350_DATACAP_E2E
• For Pax MSR read failures, retry logic is added.
• For Verifone P400, keyed clear EBT account numbers are allowed even when a device in encrypted. Swiped clear EBT account numbers are also allowed when a device is encrypted.
• For Ingenico Lane/8000 clear device, the value is fixed for SecureDeviceInit. Earlier versions returned Invalid Pad Type.

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Local Batch Report Viewer can be used to view the locally stored batch report of Host based NETePay who support support this feature and have it enabled via PSCS.

Release notes for v1.03

• Fix for an issue which prevented errors from the open batch being shown in the decline/error tab.