Please follow the steps below to complete your installation of NETePay Paymentech Host EMV - PNH 5.06.11

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiEMVUS® 1.36

Release date: 08/22/2019

Datacap’s out-of-scope ActiveX control for NETePay supporting a variety of EMV-enabled hardware options.

For information on supported devices please see our PC based POS solutions page.

Release notes for v1.36

Ingenico provided new information on how MSD-mode contactless should be enabled on Telium devices and on Tetra devices. When performing an EMVParamDownload, these changes are included in this version of dsiEMVUS.

If MSD-mode contactless is enabled, then MSD-mode contactless is enabled for all card brands. Note: for Ingenico Tetra, the Visa contactless kernel does not support MSD-mode contactless.

If EMV-mode contactless is enabled, then only EMV-mode contactless is enabled for Visa and Mastercard. EMV-mode and MSD-mode contactless are enabled for all other card brands.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

dsiPDCX® 1.62

Release date: 08/22/2019

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.62

if EMV-mode contactless is enabled then an MSD-mode tap is not allowed on the get stripe command. If MSD-mode contactless is enabled then an MSD-mode tap is still allowed on the get stripe command. Additional logic is required to determine which mode of contactless is enabled.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay Paymentech Host EMV - PNH 5.06.11

Release date: 08/14/2017

A new “EMV Cardholder Verification” parameter is added to this NETePay where the choices are “All CVMs”, “Signature” or “None”. “All CVMs” is the default on PSCS and includes Online PIN, Offline PIN, Signature and No CVM. This setting in NETePay determines the “EMV Terminal Capabilities” setting stored in the PIN pad during an EMV Param Download operation. If this parameter is changed in NETePay, then an EMV Parameter Download should be run at each workstation where a PIN pad is attached.

New build released 11/30/17 - Changes made to Data Entry Source values sent on requests where EMV Support is set to "None". This corrects a data integrity issue noticed by Mastercard.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)