Please follow the steps below to complete your installation of NETePay Vantiv (Fifth Third) Host EMV - FRH 5.06.11 Rental

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiEMVUS® 1.50

Release date: 11/18/2020

Datacap’s out-of-scope ActiveX control for NETePay supporting a variety of EMV-enabled hardware options.

For information on supported devices please see our PC based POS solutions page.

Release notes for v1.50

  • For the Verifone P400, the card removal timeout is extended from 15 seconds to 45 seconds to alleviate a lock-up issue.
  • Demand Credit is supported for EMV transactions. If the <CardType> is sent in with a value of "Credit", then any EMV transaction requires one of the supported credit AIDs to be selected by the cardholder. If the cardholder selects a Debit AID, then dsiEMVUS will return the error "Credit required and not presented".
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

dsiPDCX® 1.70

Release date: 08/28/2020

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.70

  • Support is added for a new command called GetPrePaidStripeTk1 used to return Track1 card data as long as the card number is not a major credit card.
  • Support is added for the Verifone M400 for Worldpay IP (Mercury) with 3DES DUKPT PAN encryption.
  • Support is added for the Verifone M400 for the NETePay Hosted environment with 3DES DUKPT PAN encryption.
  • Support is added for the Verifone M400 for First Data Rapid Connect with 3DES DUKPT PAN encryption.
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay Vantiv (Fifth Third) Host EMV - FRH 5.06.11 Rental

Release date: 02/20/2017

  • A new "EMV Cardholder Verification" parameter is added to this NETePay where the choices are "All CVMs", "Signature" or "None". "All CVMs" is the default on PSCS and includes Online PIN, Offline PIN, Signature and No CVM. This setting in NETePay determines the "EMV Terminal Capabilities" setting stored in the PIN pad during an EMV Param Download operation. If this parameter is changed in NETePay, then an EMV Param Download should be run at each workstation where a PIN pad is attached.
  • Support for Smart Updates which allows NETePay to be automatically updated to its versions most currently build.
  • Support for being run as a service. Please review this NETePay's userguide for details on configuring this feature.
  • Change made to "POS entry capability code" used on EMVReturn transactions to correct an issue which resulted in "SYSTEM ERROR - CALL 239" response from Vantiv.
Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)