Please follow the steps below to complete your installation of NETePay FDMS Rapid Connect Host EMV - RRH 5.06.14 Rental

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiEMVUS® 1.34

Release date: 07/16/2019

Datacap’s out-of-scope ActiveX control for NETePay supporting a variety of EMV-enabled hardware options.

For information on supported devices please see our PC based POS solutions page.

Release notes for v1.34

Support is added for the IDTech MiniSmart II device and SecureHead MSR for TSYS. The IDTech device does not encrypt the card data for TSYS. The IDTech MiniSmart firmware required is at least V2.00.020. Both devices must be accessible on a system to use either one.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

dsiPDCX® 1.61

Release date: 07/16/2019

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.61

  • Support is added for Ingenico Tetra devices for Heartland using Voltage PAN encryption.
  • For Ingenico, if Contactless EMV enabled, do not include MSD tap on get stripe command. If Contactless EMV not enabled, include MSD tap on get stripe command.
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay FDMS Rapid Connect Host EMV - RRH 5.06.14 Rental

Release date: 02/03/2017

Support added for...

  • Alphanumeric Terminal IDs.
  • Batch Summary and Batch Close if the merchant account uses Buypass on the backend.
  • FSA transactions.
  • EBT EWIC transactions. The dsiPDCX interface specification is currently being revised to include EWIC transactions.
  • TDES DUKPT P2PE using Ingenico Telium 2 devices.The following Ingenico devices are supported by the current version of dsiPDCX 1.46 with TDES DUKPT for First Data.
    • iSC250
    • iPP320
    • iPP350
    • iCMP
    • iSC480
  • New build released 2/9/17
    • Correction to MasterCard reversal formatting
  • New build released 2/28/17
    • Allow AVS data on SaleByRecordNo
    • Map tax amount of 0.00 to NoTax
    • Response code 785 treated as approval on ZeroAuth/EMVZeroAuth
Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)