Please follow the steps below to complete your installation of NETePay Heartland Portico Host EMV - HPH 5.06.11

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiEMVUS® 1.24

Release date: 06/05/2018

Datacap’s out-of-scope ActiveX control for NETePay supporting a variety of EMV-enabled hardware options.

For information on supported devices please see our PC based POS solutions page.

Release notes for v1.24

  • Support added for the following devices with Paymentech SafeTech (OnGuard) E2EE
    • Ingenico iSC250
    • Ingenico iSC480
    • Ingenico iPP320
    • Ingenico iPP350
    • Ingenico iCMP
    • Ingenico iSMP4
    • Ingenico iWL258
    • Ingenico iUC285
    • Ingenico iSelf
  • Support for clear Ingenico iUC285 and iSelf devices for Paymentech unattended without E2EE.
  • Support for EMV contactless transactions using Ingenico devices.
  • A number of changes are included for Ingenico devices to try to speed up transactions.
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

dsiPDCX® 1.52

Release date: 06/05/2018

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.52

  • Support added for the following devices with Paymentech SafeTech (OnGuard) E2EE
    • Ingenico iSC250
    • Ingenico iSC480
    • Ingenico iPP320
    • Ingenico iPP350
    • Ingenico iCMP
  • Support added for IDTECH Vendi
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay Heartland Portico Host EMV - HPH 5.06.11

Release date: 05/04/2016

A new “EMV Cardholder Verification” parameter is added to this NETePay where the choices are “All CVMs”, “Signature” or “None”. “All CVMs” is the default on PSCS and includes Online PIN, Offline PIN, Signature and No CVM. This setting in NETePay determines the “EMV Terminal Capabilities” setting stored in the PIN pad during an EMV Parameter Download operation. If this parameter is changed in NETePay, then an EMV Parameter Download should be run at each workstation where a PIN pad is attached.

New build released 7/24/17 - Changes made to data sent on EMVZeroAuth.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)