Please follow the steps below to complete your installation of NETePay Vantiv (Fifth Third) Host - FTH 5.05.05

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiPDCX® 1.62

Release date: 08/22/2019

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.62

if EMV-mode contactless is enabled then an MSD-mode tap is not allowed on the get stripe command. If MSD-mode contactless is enabled then an MSD-mode tap is still allowed on the get stripe command. Additional logic is required to determine which mode of contactless is enabled.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro

OR

DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay Vantiv (Fifth Third) Host - FTH 5.05.05

Release date: 03/28/2014

Enhanced to support:

  • Additional Terminal ID's (up to 10)
  • Mobile Client Support and Infinite Peripheral MSR support
  • Zero Authorization
  • Balance Inquiry on Prepaid cards
Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)