This NETePay has been obsoleted due to a processor host change or industry mandate and an upgrade is required. Please contact technical support by calling 215-997-8989 x143 or by emailing

Step 1 - Install Client Control

In order to communicate with this NETePay your POS may use one of the following ActiveX controls depending on the integration method chosen by the POS developer. If you are unsure of which to install please contact POS technical support.

dsiPDCX® 1.63

Release date: 10/10/2019

Datacap’s out-of-scope ActiveX control for NETePay and GIFTePay software that supports dozens of plug and play hardware options, including PIN Pads, Mag stripe readers, all-in-one touch terminals and contactless readers.

Release notes for v1.63

  • Support is added for the IDTech VP3300 device for Mercury. Supports swiped cards with Mercury PAN encryption. Its SecureDevice value is IDTVP3300_MERCURY_E2E.
  • Support is added for Ingenico Telium Devices for First Data Rapid Connect supporting OnGuard PAN encryption. This is required for First Data’s Validated P2PE. Corresponding SecureDevice values are as follows.
Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro


DSIClientX® 3.86

Release date: 09/01/2011

Datacap’s long-standing in-scope ActiveX control for NETePay and GIFTePay software.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro / Vista Pro / XP Pro
Step 2 - Install NETePay Mercury Dial Bridge for ePay 5.03

Release date: 11/05/2012

Initial MPSBridge 5.0 release supporting PSCS parameter setup and activation.

Microsoft Windows 10 Pro / 8 Pro / 7 Pro (Windows XP and Vista do not support TLS 1.2 which is now an industry requirement)